All changes are discarded. The motherboard detects the jumper setup and sets the CPU host frequency automatically. This allows the user to select the value as operating frequency. Please check if the CPU fan on the motherboard functions properly before you resume the system. Carefully insert the CPU into the socket until it fits in place.

Uploader: Daile
Date Added: 9 March 2018
File Size: 42.40 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 37763
Price: Free* [*Free Regsitration Required]

The following table lists the keys found in the legend bar with their corresponding functions. The default is 5. MAIN Use this menu to make changes to the basic system configuration. asdock

Installing an expansion card Step 1. Also remember to use a grounded wrist strap or touch a safety grounded object before you handle components. Valid password can be a 1 to 6 alphanumeric characters combination. Because the BIOS software is constantly being updated, the following BIOS setup screens and descriptions are for reference purpose only, and may not exactly k7tv2 what you see on your screen.

Select mode for the IR transmission port. The CPU fits only in one correct orientation. Chapter 1 and 2 of this manual contain introduction of the motherboard and step-by-step installation guide for new DIY system builders. Select address for Midi Port or disable Midi Port.


Gentoo Forums :: View topic – TIP: sound with ASROCK K7VT2 or similar (via82xx)

This automatically activates the Numeric Lock function after boot up. If the hard disk was asrocm formatted on an older system, BIOS Setup may detect incorrect parameters. No password has been set.

Connect an ATX power supply to the connector. If this screen is disabled, only ASRock logo is shown during the boot up process. This allows you to set the power state when the AC power restore from the previous AC power loss.

ASRock K7VT2 – motherboard – ATX – Socket A – KTA Overview – CNET

The default is The motherboard detects the jumper setup and sets the CPU host frequency automatically. Use this to set addresses for the onboard serial ports or disable Serial Ports.

Before you install the motherboard, study the configuration of your chassis to ensure that the motherboard fits into it. Remove the system unit cover if your motherboard is already in stalled in a chassis. Failure to do so may cause physical injuries to you and damages to motherboard components.

Refer to your OS documentation for more information.


ASRock K7VT2 – motherboard – ATX – Socket A – KT266A

ATX form factor 12″ x 9. However, this is not recommended unless you thoroughly knows the feature.

Use this to select Midi IRQ. Connect the fan cable to the connector matching the black wire to the ground pin. Unlock the socket by lifting the lever up to a 90 to angle. With respect to the contents of this manual, Asfock does not provide warranty of any kind, either expressed or implied, including but not limited to the implied warranties or conditions of merchantability or fitness for a particular purpose.

Use this to enable or disable floppy drive controller. The AGP slot is used to install a graphics card. Install the necessary drivers to activate the device.

Position the CPU directly above the socket such that its marked corner matches the base of the socket lever. This is necessary so that you can kv7t2 or read data from the hard disk.