How else can you tell which wire runs to which pin if you dont crack open the end? I spent almost 2 whole days trying to read information to get this working and its not working. Get the perfect match for your driver More than 5 million happy users. You still have to determine what wire is what. Display posts from previous:
|Date Added:||5 October 2013|
|File Size:||55.39 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
In my uneducated guess, I believe this means the colors listed above are correct.
This driver works on Windows 5. When the operation finishes restart your computer in order to use the updated driver.
There is no digital signature available for this driver. And you can use a USB hub if you want also, as long as its powered. This driver is compatible with the following versions of Windows: The ads help us provide this software and web site to you for free. All these USB to serial cables have a chip inside them. Never used one before. I tried the USB device viewer but neither it or windows seems to think there is a connection.
Get the perfect match for your driver More than 5 million happy users. Mon Jun 13, Go through the driver setup wizard, which will guide you; it should be pretty easy to follow.
So when you touch the red multimeter to 1 wire, and the black multimeter to one of the USB jack ends, you should see 0 Ohm or hear a Beep That means you have the same wire. Please support our project by allowing our site to show ads. If your UAC User Access Control is running please confirm the installation of the driver and run the setup with administrative rights.
The driver installation wizard will analyze your computer and will install the right driver. I measured all the wires. This driver works on Windows 5.
Touch the red multimeter lead to the other wires one at a time. Jul 6 8: Check for continuity with a multimeter between the end that you cut off and each of the wires on the cut off arkmiceo.
If you have 4 lines to test, have to guess at RX and unused line. Advertising seems to be blocked by your browser.
ArkMicro Windows 7 Driver. Going of another thread here I suspect that the wires in the cable are as follows: If your User Access Control UAC is running arkmiceo confirm the installation of the driver and run the setup with administrative rights. Wrong unfortunately, the multimeter does NOT provide power.
You still have to determine what wire is what.
DD-WRT Forum :: View topic – CA Cable Not Recognized
This Windows driver was developed by ArkMicro. The archive contains version 1. This driver was developed by Ark Pioneer Microelectronics Ltd. Driver for Ark Pioneer Microelectronics Ltd. Start the driver installer file from a user account with arkmirco rights. Installed the driver and utility from the Serial Recovery Wiki.